CAT Laser Installation Instructions
Line
Home
ArmaLaser
Lasergrips by CTC
Cat Laser Sights
Beretta Pistols
Bersa Pistols
Glock Pistols
Taurus Pistols
Installation
FAQ's
LaserMax Gunsights
Pocket Slipper

For Bersa Thunder 9 & 40, Mini Thunder 9, 40 & 45
For Beretta 92FS & 96, Gold, Centurion and Brigadier
For Taurus PT 92/99/100/101/915/940/945

Make sure your firearm is unloaded while following these installation procedures. 
Safety is always the number one priority.

Note: For shipping integrity, the mount panels have been fastened together. Before you begin installation carefully detach mounting panels by removing the anchoring screws with the largest wrench provided with the CAT laser device.

Line

:: MOUNTING THE CAT LASER TO YOUR BERETTA, TAURUS OR BERSA PISTOL

1
instr_beretta_001


    Install laser module housing in the left mount panel by first inserting the switch side module in a angle to the internal side of the mounting panel, ensure that the switch lever clears the side of the mounting panel. When properly done the module housing will firmly snap into the internal cavity of the panel
     

2
instr_beretta_002


    Install left support panel and module housing on trigger guard as shown in this image.
     

3
instr_beretta_003


    Insert mount left support panel with module housing in pistol frame, hold them in position with one hand while inserting right mount support panel, ensure that the switch lever clears the side of the support panel (you may have to press on the module housing slightly upwards and back in order to properly snapped into place) do not use excessive force.
     

4
instr_beretta_004


Install anchoring screws. Insert central screw first do not over tighten it at this time, insert remaining screws (short screw is the trigger guard anchoring screw) and proceed to tighten all of them progressively clockwise until support panels are firmly secure to frame. Even though the anchoring system in the support panels are metallic do not over tighten these screws. Doing so will damage the mount support panel and will void the warranty.
 
Line

:: MAKING WINDAGE AND ELEVATION ADJUSTMENTS ON THE CAT LASER FOR YOUR BERETTA, TAURUS OR BERSA PISTOL

1
instr_warning


    Warning: The laser module tension screw located on the upper left side of the module housing next to the laser warning sticker is already set to the precise adjustment at the factory,
    DO NOT CHANGE THE FACTORY SETTING OF THIS SCREW.
     

2
instr_beretta_007


    Gently turn the adjustment screw located at the forward right side of the device clock wise with provided wrench (small one) to drift aim point to the left. Reverse the procedure to bring point of aim down. Keep in mind that the point of aim most be correlative to bullet point of impact on target.
     

3
instr_beretta_00602


    Elevation Adjustment
    Gently turn the adjustment screw located at the bottom of the devise clockwise to move point of aim upwards. Reverse the procedure to lower the point of aim. Keep in mind that the point of aim must be correlative to bullet point of impact on the target.
     
Line

:: BATTERY REPLACEMENT FOR THE CAT LASER FOR BERETTA, TAURUS OR BERSA PISTOLS
instr_beretta_008

    Remove the cover located under unit on-off switch by unscrewing it in a counterclockwise direction. Replace batteries using only type LLC44 or equivalent. Make certain to install them with the positive pole (silver flat side) towards the batteries cover (out side of the device) do not over-tighten the cover.
     
Line
[Home] [Laser Sights] [Pocket Holsters] [Gallery of Guns] [Return Policy] [Contact Us]